Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This is the important steps. SSH in to CIMC IP, if the SOL is disabled, after typing connect host, it shows Cisco Serial over LAN (SOL) is disabled. Have to go to the steps 3 in below steps to enable it.
Step 1 SSH ip-address-of-cimc-l admin
Step 2 L...
Hi Ric,Thanks for response. I did not install the FUS twice. Only the image 8.0.110.0 twice. Opened the TAC case, the engineer tried to downgrade to 7.6.130 but failed. He formatted the flash memory and installed a recovery version 7.0.X then upgrade...
