Hi ,I have a question when we configure IP sla for dynamic fail over it works as expected but when the link switched to the back up link it has intermittently disconnects and then comes back up.We hav etested its not the issue with the service provid...
Hi ,When I try to access my console port(3640 Router with 1 module with 2 ethernet card ) I am not able to access the IOS or type any command .I am getting the following unredeable message.šù¤ ʼù°þè˜þè° þþÑîçúþÊù þøáþþTÃ...
Hi , I am in a phase to implement a network at one of the customers location and they have 5 branch offices.I am new if anyone has a experience.I am confused from where to start.As this is my first project for full implementation.Also if some one can...
Hi Jawad,This works for me but the issue I am seeing is that there are unsucessful ping after it fails over to the backup link, and if I connect a PC directly to the provider router there are no ping drops.Also the weard part is there are only 3 unsu...
Hi Rick ,The steps I followed are - changed the console cable to see if it was faulty- tried to remove the modules and then boot the system - tried to keep 1 module and remove other and vice versa- then change the baud rate on the console hyper term ...
Hi ,The config register was changed to the 0x3122 which was creating all the problem and changed that to 0x2102 the factory default one.and also had to change the console cable baud rate to enter in the router.Finally I got through it.Thanks to all o...
Hi,The console cable is working fine with the other routers and giving me the expected output on console,so I think there is no problem with the console cable.I also tried using the new cable still it gives the same error.Do you think that as I had u...
