About Guillermo Vitas

Guillermo Vitas · 02-12-2013

Hello.I have a problem when trying to access from a workstation on the internal network to an external FTP server using Explicit FTPS. After the server requires the client TLS Authentication the client inits TLS but the connection is closed by timeou...

Guillermo Vitas · 02-05-2013

I have inherited an asa 5510 whit 4GE SSM module installed. The asa runs fine, but i can not use the 4GE SSM ports. Using ASDM or console i can get and configure the gigabitethernet1/x ports but i can not get traffic on it.The ping from the console ...

Guillermo Vitas · 08-26-2014

Hi.2960-Plus runs with CNA Version 6.Thanks Vinod. Best regards

Guillermo Vitas · 08-25-2014

Hi You know when will be CNA v 6 available?At the moment only CNA 5.8.9.1 version is available and the 2960-plus is not supported. Best regards. SORRY!!!!Version 6 is available from July 8.I will try ASAP. Best regards.

Guillermo Vitas · 02-27-2013

Hi.Same problem with WS-C2950G-48-EI and CNA 5.8.(2)Yes I know it is an old device but...Any idea?Regards

Guillermo Vitas · 02-27-2013

Hello.Sorry by the huge delay on the response.I have checked if client is in Passive or Active Mode. But on the client i can see the error before it enters in acttive or passive mode.The error arises on the credential interchange I think. But creden...

Guillermo Vitas · 02-20-2013

Hi Jocamare.Thanks for your response.The capture I sent was taken after disabling FTP inspection. I am not sure if using passive or active mode, I think was taken using passive mode. I will double check this and recapture traffic asap.regards.

Member Since	‎02-05-2013 02:37 AM
Date Last Visited	‎12-01-2020 07:27 AM
Posts	12
Total Helpful Votes Received	5

User Statistics

User Activity

Asa 5510. FTPS Explicit client fails at Init TLS stage

asa 5510 4GE SSM

Hi.2960-Plus runs with CNA

Hi You know when will be

WS-C2950T-48-SI is not supported as community member

Asa 5510. FTPS Explicit client fails at Init TLS stage

Asa 5510. FTPS Explicit client fails at Init TLS stage