I loaded the image c2960-lanbase-mz.122-35.SE5.bin into a C-2960S-48TS switch. I deleted the old image and now when I boot the switch it goes to this point and stops:It de-compresses the image and then goes to installing and it hangs up there. Th...
I am able to enter things via the keyboard but the flash_init command does not finish. It looks like this: switch: flash_initInitializing Flash...mifs[2]: 10 files, 1 directoriesmifs[2]: Total bytes : 1806336mifs[2]: Bytes used : 612352mifs[2]: B...
Yes, I know how to use xmodem or boot from the USB as has been suggested. But the problem is getting to rommon which is where I need to be to run either of those processes. From what I described is happening during the flash_init command does ...
Thank you for looking at my question. Again, I am unable to get to rommon mode. When I try to run the flash_init command it hangs up and never finishes. So I never get to the load_helper command and thus never get to the ROMmon mode.
Thank you for your response. But perhaps my initial post was not clear enough. The actual problem I'm having is that I cannot get into the rommon mode. I have to break the boot sequence and then run the flash_init and load helper commands and...