About Sakthi Malli

Sakthi Malli · 07-03-2017

Introduction ZTP or Zero Touch Provisioning was introduced to reduce the human interaction in the provision of XR devices. ZTP helps in auto provisioning after the software installation of the router using iPXE. This document is intended for first t...

Sakthi Malli · 02-24-2016

"show route afi-all [vrf [all|word]] summary" only provides the total number of prefixes and wouldn't actually provide the ECMP paths that you like to see. Can you try the "show bgp scale" command with and without "maximum-path" config and see if y...

Sakthi Malli · 02-24-2016

Can you try remove/re-add "aggregate-address" statement or hard-reset BGP session to see if it helps Thanks

Sakthi Malli · 02-13-2016

I don't believe we have the same command in XR. However any rib-failed route will have "r" appended in the output of "show bgp vpnv4 unicast" or equivalent commands to indicate a "rib-failure" Thanks

Sakthi Malli · 02-11-2016

show bgp <prefix> [detail] should list the prefixes with multipath. Like in the example below: Note however the output is for eBGP prefix. sh bgp 20.5.6.0Wed Jan 29 13:08:54.458 ESTBGP routing table entry for 20.5.6.0/24Versions:Process bRIB/RIB Send...

Sakthi Malli · 02-11-2016

This can be easily achieved with auto-archive. This has been answered in the past. Take a look at the link below. https://supportforums.cisco.com/discussion/11258516/archive-command HTH

Member Since	‎03-31-2008 11:11 AM
Date Last Visited	‎10-09-2019 12:10 AM
Posts	6
Total Helpful Votes Received	10

User Statistics

User Activity

ZTP (Zero Touch Provisioning) Implementation & Troubleshooting tips

"show route afi-all [vrf [all

Can you try remove/re-add

I don't believe we have the

show bgp <prefix> [detail]

This can be easily achieved