Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,I am looking into a soloution where by a standalone PC with a ISDN Modem attached can dail into a network talking to a router set up using ISDN with CHAP and CLI.Is that possible ie. a will CHAP work in this scenario using a ISDN modem to a...
--begin ciscomoderator note-- The following post has been edited to remove potentially confidential information. Please refrain from posting confidential information on the site to reduce security risks to your network. -- end ciscomoderator note -- ...
I am trying to simulate a wan conection using two 1600 series routers with Serial 0 ports and two X21 cables giving DCE to DTE connection.I tried a clockrate of 56000 but not sure if this correct as show CDP shows the neibouring routers but a ping do...
Hi there,I'm trying to establish connectivity from a 3600 router to a 2600 I can see layers 1,2 establish ok but a debug on the far en router shows the following02:47:32: Low Layer Compat i = 0x889002:47:32: ISDN BR0/0: llc valid, speed 64, c...
Hi All,I recently encountered a problem with a 3600 series router whereby a while trying to bring up a BRI onterface with the command "no shutdown" my telnet session froze and I could not re-establish a telnet connection, On further investigation I f...
Hi there,I have telneted into the router and had a look at the CPU, the highest usage is : PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min TTY Process 25 913040 992092 920 0.57% 0.73% 0.72% 0 IP Input...
Yes we do Dialer interfaces 1,2,3, 4+5 will be the new onesSorry had fat fingers on the privious config:interface BRI1/0 no ip address ip inspect ********** out encapsulation ppp dialer rotary-group 4 dialer priority 255 isdn switch-type basic-net3 n...
Thanks for your quick response,The freezing has occurred on two seperate occasions and actually only happened when I tried to bring up the BRI1/1 interface the config for the router is quite big so I have attached the additons which were made to add ...
