About vstepanov

vstepanov · 09-09-2019

Hi, collegues, I have a question about parser view. There is a format for commandscommands parser-mode {include | include-exclusive | exclude} [all] commandAnd in IOS we have these parser-modes only for some parts of the configuration, for example, i...

vstepanov · 07-30-2019

Hello colleagues, sorry for stupid question. Is there any way to check counters for shaper on catalyst 9300 (IOS-XE 16.9.2)?I am surprised that show policy-map interface command shows only configured values, but not any counter.For example Class-ma...

vstepanov · 07-24-2019

Hello colleagues, the history - we had DMVPN configured on different models 800, 2800, 2900 series with different IOS versions. Everything works quite good. Recently we added two new routers - c1111-4p, with different IOS versions - 16.8.1 and 16.9.3...

vstepanov · 08-03-2017

Hello, please, could someone help me to find information about if C9300-NM-8X card supports sfp or sfp+ only. So is it possible to use for 1gigabitethernet port. The only indirect prove that it's possible I found in the document http://www.cisco.com...

vstepanov · 07-31-2019

the same problem on catalyst 9300 IOS-XE 16.9.2. At the same time it works on catalyst 9300 IOS-XE 16.6.1

vstepanov · 07-24-2019

forgot to add, I captured traffic from tunnel interface and it is clear that the spoke doesn't send the first packet to the hub, so it is not dropped on the hub of further.

vstepanov · 04-13-2018

no, flash_init doesn't change the mode to read-write.

vstepanov · 04-13-2018

of cause, I know all these commands, but I don't need them. I need the command to change the read-only mode to read-write in rommon mode, or the reference to the documentation why it is not possible to do like it was possible before.

vstepanov · 04-13-2018

Of cause I tried to google. Just found a lot of similar questions here and nobody has answered yet, neither from cisco nor community side. It seems like nobody can find by googling the answer. Again, your answer "Don't try to copy the .bin file to...

Member Since	‎08-03-2017 09:53 AM
Date Last Visited	‎02-05-2024 12:29 AM
Posts	15
Total Helpful Votes Received	15

User Statistics

User Activity

parser view - how to allow all nested commands in case there is no corresponding parser mode

how to view shaper stats on catalyst 9300

DMVPN phase 2 - first packet drop for spoke-spoke traffic

C9300-NM-8X card - only for sfp+?

Re: ISR 4221 Guestshell Network Access

Re: DMVPN phase 2 - first packet drop for spoke-spoke traffic

Re: Flash - Read only file system

Re: Flash - Read only file system

Re: Flash - Read only file system