Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have a cable connected from isp to my switch port g1/0/1its up and its listening for the mac of the isp side ip. traffic is working fine through it. i have deployed nms and it wasnt showing traffic on that interface. so i manually checked that p...
hii cannot login to uccx editor. earlier i was able to login to it . now i cant login with those credentials. Nor can i loin to "Cisco unified CCX Administration". I can login to CLI of uccx and getting below resultadmin:show uccx appadmin administra...
Hi I have an access control rule that permits traffic from server to another server via tcp/5000 and an intrusion policy is applied to this rule.there is one intrusion rule hitting where the rule definition has in the destination ports different port...
hii have cisco 6500 series core switch and facing a bizarre issue with data speed transfer.I have two vlans svi for which is defined on this switch (core6500). these vlans are transported to another switch (sw5) via lacp etherchannel which is providi...
HiI had configured elephant flow detection but on remediation actions it says below in tooltip. So does it means that FTD2110 model wont support automatically do remediation of elephant flows ?Also if there is an elephant flow detected and that snort...
its huawei isp switch and the only exit path for all traffic from our core switch to internet. there is no issue wiht the port itself. i have its perfectly fine. spanning tree is not blocking it.sh spanning-tree interface gigabitEthernet 1/0/1Vlan Ro...
these are two 3850 switches in stack.its not showing traffic for all interfaces of one of the switch in stack. Taffic is passing through those interfaces perfectly fine. I even connected laptop to this port and transferred multi gb file and still sta...
same result there. i used that command . it seems that i am not getting statistics on nms for the fist switch in stack. neither do i see counters for any of interface using below command on any interface of the first member switch. sh int g1/0/1Gigab...
This will set next hop for traffic from vlan 20 to vlan 24 as 10.11.101.50. where these are subnets defined on this very core switch so it should not be pbr'ed. by adding a deny for them at the top of acl i am excluding them from pbr . The reason fo...
