Hello all Network Guru,
I have set up the REP ring for 2 Redundant IE5000 industrial switches and 3 Access switches.
these two IE5000 switches have been configured as HSRP.
for the REP ring:
two ports in 1st IE5000 have been configured as Primary Edg...
Hi,
if two Cisco IE 5000 industrial switches be configured as a horizontal stack, can other ports be configured as REP?
see attached for my proposal.
Thanks.
HiREP ring has the following advantages1. It is ring obviously2. The network convergence is better than EtherChannel. REP can be 50-150ms, while EtherChannel is around sub 250ms.Refer to attached screen shot I found somewhere.[cid:image001.jpg@01D657...
Thanks, Georg
ironically, both Distribution switch SW01 and SW02 are in the same server and network panel.
Figure 7 in the file you mentioned on page 17 gave me the idea.
Why not configure the edge ports in other access switches instead in the dist...
I used Packet tracer to do the testing, however, the 'IP Routing" is not available in any switch in the Packet Tracer.
I do not have physical hardware available for the testing.
If we need this command "ip route 0.0.0.0 0.0.0.0 200.1.1.2", then do we...