Hello,
I have two ASAs successfully connected and passing traffic to each other via site to site VPN. I'd like to route traffic for a specific website through that tunnel, so the far end serves the website to hosts on the other side of the tunnel. ...
Hello. I've a 5520 in failover mode 8.2(5)59 and its enable password is different when I'm connecting via telnet vs SSH. The other ASA does not have this issue. Here are the AAA settings for the ASA in question:exp-jka-fwl1a# sh run aaaaaa authent...
My 5505 drops me off Blizzard games (World of WarCraft and Overwatch) every half hour or so but not based on play time. For example, earlier today I was playing WoW. I got disconnected from the game every hour and half hour on the clock around 4-7 ...
Hi folks,I'm having trouble with a site-to-site tunnel setup. At this point I'd just like to be able to verify that a connection attempt is being made from the ASA. What's the best way to check via ASDM? I tried packet capture, but I never saw any...
I can't find a full download for CCP 3.4 for Windows. The only version that seems to offer a full download (100+ MB) is 2.8 so I've been trying to get that to work.
I've tried a few different Java versions on both Windows. I've also installed the l...
To clarify, I want site A to be able to access an Internet website by routing the request through the tunnel to site B. Site B does not host the site.
As of right now, site A attempts to access the website via their Internet connection. The website...
The problem seems to have cleared up on its own. The RST, ACK commands make me think it was a problem on Blizzard's end, but it seems weird that they were able to tell when I was using the firewall...
I confirmed that the issue does not happen when I'm directly connected to my cable modem.Anyone have any ideas on how I might continue troubleshooting?
I tried to get the packet tracer going and even recruited a network engineer to assist and yet we never saw any traffic or attempts being made to contact the peer. Finally in frustration I deleted the tunnel settings and started from scratch with th...
Thanks for the suggestions.So on the tunnel I'm experimenting with I've defined the following:10.187.0.0/16 - local network10.199.0.0/16 - remote networkHowever when I ping from a host with the IP 10.187.1.6 to the host 10.199.2.30, the results of "s...
