Hello!I wish to use cisco router as ntp-client and get time update from internal NTP server (stratum 2) and configured "ntp disable" on all interfaces in order to prevent the router acts as ntp server to other devices. NTP configuration is below. How...
Hi All, Seek your advise on this. I'm exploring mpls full mesh design 4 sites (HQ, BR1, BR2 & BR3) with two PE routers. HQ & BR1 are connecting to PE1 with "vrf HQ" & "vrf BR1" and BR2, BR3 to PE2 with "vrf BR2" & "vrf BR3" likewise. All PE-CE use os...
Hello !
I am doing NAT lab in GNS3 with ASAv & trying to allow web server in "dmz" zone access from "outside" and "inside" zone by using "object nat". But both outside & inside failed access to DMZ's web server. The acls are already in place. I've ...
Hi All,
I need some help..
In my corporate network (office-A), there is one application server & NATted public ip to access clients from Internet. Now planning to move this application server to different network (office-B). Due to some constraint, t...
Hi All,
I would like to monitor Ipsec VPN tunnel logs because having intermittent connection loss to remote host.
May I know below debug commands are safe to run on prod router, any performance impacted? or If you have any better solution please sug...
Thank you everyone and wishing prosperous happy new year 2023!I might have misinterpreted ntp disable as it’s preventing router interface being as ntp server but actually its blocked everything In order to work router as ntp client, which one will b...
Thanks @MHM Cisco World Just some updates, I have total 3x routers as not-client and initially all routers ntp configuration were same.Now I did changes different configuration in router as belowRT01:removed “ntp disable” under interface associated w...
Hi Harold, Firstly Thank You!!By changing ospf loopback interface to /32 finally paid off :) Now all my CE routers are able to ping each other. I know ldp session use loopback interface as source but really didn't think /32 play as vital role. Got to...
Hi Harold, I used "mpls ldp autoconfig" under IGP protocol on all P, PE1 & PE2 routers. router ospf 1mpls ldp autoconfiglog-adjacency-changes Best regards,
