About carl robinson

carl robinson · 10-29-2020

I have 2 ESXi Host on a pair of 10G fex's via port-channel without LACP.(2) vmotion Nics, (2) Data Nics.We can see the vmotion copy the images successfully over the vmotion Nics. I was able to see the RARP broadcast, (VSphere , "Switch Notify" is ena...

carl robinson · 11-02-2020

Thank you, Kirk.I seem to be loosing layer 2 information in the captures.We tested again with a single nic and it worked flawlessly.So the standard vswitch is seeing an issue with the standard port-channel.We are not running lacp.

carl robinson · 07-26-2018

run a tdr test on your cables, make sure they are within spec. verify the port with another poe device or a tester. I have been searching for similar answers for some Angel Eye Cameras. I have seen some suggestions that the POE spikes on startup then...

carl robinson · 08-23-2014

The firewall can be managed via up sown pretty easily as a node.as long as you enableSNMP Host and the interface Poll CommunitySNMP Host and the interface Poll VersionOnce you get that going you will probabaly need to dig a little for the IKE OID's t...

Member Since	‎06-23-2011 11:55 AM
Date Last Visited	‎11-08-2020 07:08 AM
Posts	5
Total Helpful Votes Received	5

User Statistics

User Activity

Vmotion Failure after copy.

Re: Vmotion Failure after copy.

Re: IP Camera not working on Cisco 3850 PoE port

The firewall can be managed