About azaghul33

azaghul33 · 04-24-2013

I recently purchased a UC520W for use at home to replace an 877W, would like it to do all the front-end stuff, NAT, firewall, PPPoE, voice. Have installed a 1801 in front of it to bridge ADSL to Ethernet (almost), but having some issues. 1801 conf...

azaghul33 · 09-10-2011

I am running an 877W in the home that for the most part works fine, however after being connected for a variable amount of time I partially loose my DSL connection. Line sync stays up, but the traffic is lost.A shut/no sut of the atm or dialer interf...

azaghul33 · 05-01-2013

Looks to have been an MTU problem (which was on my to-do list [but forgotten]), configured for 1452 on both the ATM and FastEthernet interfaces on the 1801 and FastEthernet on the UC520, all OK for the past 24 hours.Thanks for the assist!

azaghul33 · 09-16-2011

i had the same prob with speed on my old ADSL1 link, it got flakey and would fully reset the link (carrier sync lost) anywhere between 7.2 and 7.5Mb/s, kept my d/l speed to 7.0Mb/s or under and I was finehowever this prob will keep carrier sync, but ...

azaghul33 · 09-12-2011

I have an ADSL filter installed on the fall-back phone line when not using SIP

azaghul33 · 09-12-2011

as the crow flies, about 900m to the exchange, allowing for a less direct route, probably about 1250m

azaghul33 · 09-12-2011

sh dsl int atm 0 attached

Member Since	‎09-10-2011 12:29 AM
Date Last Visited	‎08-18-2017 04:00 AM
Posts	10

User Statistics

User Activity

Cisco 1801 ATM -> Ethernet bridge issue

877W intermitant DSL loss

Re: Cisco 1801 ATM -> Ethernet bridge issue

Re: 877W intermitant DSL loss

877W intermitant DSL loss

877W intermitant DSL loss

Re: 877W intermitant DSL loss