Hello, we have devices in a subnet 10.118.0.0/24 that are configured some of then with snmpV2 and other with snmpV3. If you try to run a discovery using snmpV2 and snmpV3 for the subnet the collector said that this is not able. We have to ran a disco...
We have MPLS circuit that flap last week, as appear in the logs, BGP was down because we lost BFD. I have also and IP SLA that doesn't showed any issue and was UP all the time.Yesterday I ran a packet capture in the router interface that connect wit...
Hello, in all DMVPN documentation that I have consulted, EIGRP is always the recommended overlay routing protocol, also that DMVPN was mainly designed for EIGRP. Why is EIGRP recommended over BGP ?
Thanks.
Hello. The default collection profile use a lot of dataset, are all needed ? for example, If I only need to know the status of the contracts, what dataset we must use?
CSPC 2.8 Don't boot we are getting the error:
Telling INIT to go to single user mode.
init: rc main process (xxxx) killed by TERM signal.
Give root password for maintenance
(or type Control-D to continue):
I tried Control-D, but it goes back to the...
Thank Chris, This solution works althought IE take some time to open the page. It said thet the certificate is not valid, I'm using a selft signed certificate.Best,Manuel