Eugen Bitca
Level 1
Level 1
Member since ‎07-15-2010
‎10-13-2021

User Statistics

  • 63 Posts
  • 0 Solutions
  • 57 Helpful votes Given
  • 45 Helpful votes Received
Recent Badges
 30 Helpful Vote
10 Helpful Vote
1 Helpful Vote
20 Replies
10 Replies
5 Replies

User Activity

Hi, We have the following ISE deployment with maximum number of session 5000:Node 1 - Running Admin(Primary) + MnT (Secondary) + PSN [CPU 14, RAM 24GB, Disk 600GB]Node 2 - Running Admin(Secondary) + MnT (Primary) + PSN [CPU 14, RAM 24GB, Disk 600GB]N...
Hello, Cisco Phone is trying to atuhenticate on data vlan even port is configured with voice vlan.Only Radius and Device Sensor are used.PC and Phone are authenticated using MAB.Access Device: WS-C2960S-F24PS-L()(15.2(2)E9)!Port-Config:interface Fast...
Hello,   Cluster Transparent Mode (2 units), only 1-2 flows to the same destination host are successful, all others fail. If I remove a unit from cluster (anyone), everything is OK. When I add a unit to the cluster, cluster is OK and healthy, but onl...
Hello, I have macsec (manual mode) between 4500-x and Cat6500 Sup2. How can I verifiy if MACSEC do realy encrypt traffic, SPAN session shows traffic unencrypted.   Configuration on both sides: interface GigabitEthernet1/1 switchport mode trunk switch...
Hello, A typical Data Center ASA cluster with vPC and VSS(file attached) All interfaces and port-channels are up, vPC, VSS, Cluster all OK. 1. From Core-S1 Vlan 200 I can reach Vlan 200 on Servers LAN2. From Core-S1 Vlan 200 I can reach ip 10.44.12...
Community Statistics
Member Since ‎07-15-2010 05:08 AM
Date Last Visited ‎10-13-2021 12:10 AM
Posts 63
Total Helpful Votes Received 45
Helpful Votes From
Helpful Votes Given To