About Fabio Funaki

Fabio Funaki · 09-22-2016

Hi, I have an Cisco CUBE with two SIP Trunks, one for an NEC PABX and another for an Siemens PABX. [NEC Phone] - [NEC PABX] - sip trunk - [CUBE] - sip trunk - [Alcatel PABX] - [Alcatel Phone] When I start an call from an phone of NEC PABX I saw on...

Fabio Funaki · 09-21-2016

Hi, Does anybody know if has some configuration that unable the call to show the ID (not the call ID, is the number before the colon) on show call active voice brief on a voice gateway? Telephony call-legs: 0SIP call-legs: 2H323 call-legs: 0Call a...

Fabio Funaki · 06-19-2012

Hi,Someone know if I can enable feature access code for Cisco SIP Phones on CME and how to do that?Rgds,Fabio

Fabio Funaki · 06-06-2012

Hi,Someone has a working config of CME using SIP Phone 3905 and with pickup working?My issue is that pickup doesn't work.When I press the feature button then pickup I get reorder tone.I have configured pickup-group on voice register dn and the servic...

Fabio Funaki · 06-05-2012

Someone know if I can have two calls on a Cisco SIP Phone 3905 on CME 8.8?And how can I (I didn't find on user or admin guide):1. answer a second call2. toggle between callsRgds,Fabio

Fabio Funaki · 09-22-2016

Hi Mohammed! The direct negotiation between the PABX didn't work before! CUBE is the solution that we believe that can be the middle element to enable this interwork. One thing that is too strange is that I have two m lines with the same content (p...

Fabio Funaki · 09-22-2016

My IOS is relatively new: 15.4(3)M5, and I have two enviroments with the same version, but just in one the issue happens!

Fabio Funaki · 07-04-2016

Hi Ilana! No, I didn't find how to enable Feature Access Code for SIP Phones, on the Cisco Unified Communications Manager Express System Administrator Guide says only for SCCP devices. Regards, Fabio Funaki

Fabio Funaki · 07-15-2015

I'm running on this issue, but with an 7821, I opened a TAC case to check why it happens.As a workaround I configured another time zone that can show the correct time and I will proceed with TAC to try to identify why this happen. Regards,

Fabio Funaki · 01-23-2013

Hi Claudio,You have to configure the command 'call-park system application' under telephony service, and then regenerate the cnf-files.Rgds

Member Since	‎07-27-2005 01:16 PM
Date Last Visited	‎03-18-2021 01:10 PM
Posts	31
Total Helpful Votes Received	44

User Statistics

User Activity

CUBE Getting "2 Valid Audio Mlines is not supported, hence disconnect the call" from an Alcatel PABX

Voice command "show call active voice brief" showing 0 as ID for the call

CME - Feature Access Code (fac) for Cisco SIP Phones

CME SIP Pickup

CP3905 - Dual Line on CME 8.8

Hi Mohammed!

My IOS is relatively new: 15

Hi Ilana!

I'm running on this issue,

CME SIP Pickup