Cannot access console baud rate has been changed by customer and I have tried all the standard ones 1200,2400 ect, have tried the J7 baud jumper on the mother board....?
When I use the recomended procedure in the provisioning documentationprofile.xml<flat-profile><GPP_A> 123456</GPP_A></flat-profile>openssl enc –e –aes-256-cbc –k SecretPhrase1234 –in profile.xml –out profile.cfgand I and add the relevant key to my pr...
I have tried jumper combination/s on the mother board to no avail, I am accessing direct (console to PC), I need to access rommon to delete the config, as it has been returned from the customer. I can access the console via putty but customer changed...
it is a framing thing If I am sending 9600 8-1-N and the router is sending 4800 7-1-E then I will recieve garble. When I type unset BAUD it recieves 2j1l2j3l, an this is not a valid command.I need some information regarding a jumper settings that wil...
