About hvangruijthuijsen

hvangruijthuijsen · 06-30-2014

Hello,Because of security we have to allow SNMP requests only from MGT VLAN's.This is how I want to handle it:ip access-list extended SECURE-SNMP remark *** mgt vlans *** deny udp 172.16.21.0 0.0.0.255 any eq snmp deny udp any eq snmp 172.16.21.0 0.0...

hvangruijthuijsen · 02-13-2014

Currently we have AIR-LAP1142N-E-K9 in our office building.This device is end of sales, but our management wants to have better coverage in our conference rooms.The product replacement advice is Aironet 2600 series.Will the 2600 series cooperate with...

hvangruijthuijsen · 07-22-2013

We hit a problem with our Nexus 1000v which runs in HA mode.Version of the Nexus 1000v: 4.2(1)SV1(5.2)Our primary Nexus 1000v does not complete booting, it hangs on message:loader loading stage1.5.Loader loading, please wait.........Command "show sys...

hvangruijthuijsen · 04-10-2013

We use Cisco LMS Prime 4.1 to archive our Cisco Equipment configurations.Now we want to store the configurations off site.Does anybody have suggestions how to handle this?

hvangruijthuijsen · 04-02-2013

Hello,We use LMS Prime 4.1 Soft Appliance.on the 23rd of March, the disk ran full and LMS crashed. After investigating and rebuilding database according to instructions, a lot is up- and running again except for the ANIServer.Currently the ANIServer ...

hvangruijthuijsen · 03-28-2017

Simple solution if you have a layer 3 switch. Create a port as a router port, so no switchport and configure an IP address on it. Create a port with access port in vlan you want to have up. Connect both ports to each other with a standard CAT5 or 6 c...

hvangruijthuijsen · 05-13-2016

Thanks Roopa. Best Regards, Henk

hvangruijthuijsen · 05-13-2016

Does the 2960-X support: sdm prefer lanbase routing This to be able to use the switch as a simple L3 switch like the old 2960 switches.

hvangruijthuijsen · 12-23-2014

Thanks fuhrersk8...

hvangruijthuijsen · 12-22-2014

I documenting our setup and also want to document how to recover from a Supervisor failure.My question: can I also follow the document replace_supervisor_module_in_cisco_catalyst_6500.pdf when running version: 15.0(1)SY5

Member Since	‎06-14-2006 12:44 PM
Date Last Visited	‎11-01-2017 12:20 PM
Posts	31
Total Helpful Votes Received	5

User Statistics

User Activity

VACL for blocking SNMP read/write

Mixed usage of Aironet 1140 and Aironet 2600 series

Problem with Primary Cisco Nexus 1000v hangs on loader loading, please wait

Cisco LMS Prime 4.1 Store Device Configurations External

Cisco LMS Prime 4.1 ANIServer problem

Simpel solution if you have a

Thanks Roopa.

Does the 2960-X support:

Thanks fuhrersk8...

I documenting our setup and