Hi Lucien.Why do you need the associate the the physical port to the port-channel out of the config-sync command.Is it not possible to do this in config sync, and why not.??ThanksAd
Hi,Copy "show version" and stack trace output in the cisco output interpreter.https://www.cisco.com/cgi-bin/Support/OutputInterpreter/home.plYou see than Possible bug matches.Regards
Leave the config as it is, but put ip nat outside on the interface FastEthernet 0/1.Traffic that hits acces-list 1 will be nated on loopback1.Return traffic goes directly to 20.20.20.1, without going to the loopback1.-