Running into an issue upgrading a ASR9000. There is not enough space on Disk0: to upload the new image. My question is are the directories able to be deleted to make space for the new image?Can anything with the 4.2.0 be deleted before the upgrade?...
a 6509 and a 4506 with 2, 1gb interfaces in a portchannel. Bring it up and everything is fine. Save the config and reload either switch and the interfaces stay in Not Connected state. Either doing a No Shut or a physical unplug the SFP and plug i...
Getting an error from NCS.The following error is obvserved in NCS CleanAir Sensor Status: 'Down' Error Code: 'CleanAir sensor is not operational due to crash. Please reset AP to resolve problem.'The WLC version is 7.0.220.0. The AP IOS version is 1...
Has anyone seen Duplex MisMatch errors on a N7k with a LAG going to the 5508 WLC? WLC code is 7.0.203.0. I found a BUG that is private to Cisco ( CSCth11041 ) that looks like it, but I want to make sure.Any help would be appreciated.Regards,Hunter
Show redundancy output. You can see slow 6 is active.NYCWS-ACCESS-SW19B#sh redRedundant System Information :------------------------------ Available system uptime = 3 hours, 6 minutesSwitchovers system experienced = 0 Standby failu...
SSO is configured correctly and they are in HOT Active/Standby states. And if we failover it works fine. Just when the switch is booted up slot 6 becomes active. One of the SUP's was RMA'd recently.