Dear fiends, I am trying to implement a contingency routing scheme using floating static routes.In this case I do not want to use hot stand by. I could not find any text about how Cisco performs dead gateway detection. I have a Lan (DMZ) with ...
Friends, This is a new, clean version of my older post "Frame Relay Cannot Receive Advertisement". As we had a lot of replies, the chain was hard to deal with. Three little adjustements were done, some debug data was produced and the question ...
Dear Friends,I have a frame-relay small network with a star topology. Core router is a 3640 and 7 branches use 1750.Core router has 7 subinterfaces point-to-point configured in one an interface.5 branches have subinterfaces in their interface and...
Hi, We have a small network with Cisco routers with a HQ and seven branches. Now, we have changed from dedicated leased lines to frame-relay. Our configuration is: seven subinterfaces in point-to-point on the core router and related config in the ...
Dear friends,I would like to know if exist any way to know the peak traffic volume in one specific moment.The sh int command displays a 5 minutes rate that is not accurate if I want to know the traffic peak for a burst, for instance (or any small pe...
Ok. But I would like to use static routes only. Just after this question was posted, I found out, in the book "High Availability Networking with Cisco" that if I have static route-to-1 and route-to-2 (with different administrative distance) IOS will...
Last data makes easy to see what is happening. CORE router receive a RIP v2 advertisement from each remote branch. But, RIP router engine does not use these routes in core´s rip data base. What reason?------------------------debug ip rip listing...
Listing DEBUG IP RIPBelow is this listing. Core is receiving all routes from branches. What is happening? Core receives routes but does not use them to update RIP Route table.-------------------------------------------------2003-11-04 15:11:13 Local7...
I dont know what FE is. But ALL data is flowing to and from branch. Core advertisements are received, but branch advertisements does not reach core. Paulo
Sh ip route CORE/BRANCH---------------------------------------------CORE-ROT-001#sh ip routeCodes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF ...
