Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All, In the HUB.... Router Side due to AS prepond... Link1 is primary and Link2 Is secondary for all the spoke sites Routing.But I need at one specific spoke site... Link2 should be primary and Link1 as secondary....By what local BGP commands we...
Dear Friends, policy map enabled as below , need to drop packets above 1024 ( 1MBPS ) , suggest better commands to implement the same ( consider it is a video streaming traffic ) policy-map outbound-policy2 class uniqos2 bandwidth 1024service-policy...
while applying ACS 5.3 Config on Cisco Switches , due to partial config the username and password is not working ....kindly guide how to recover the password ; even after reboot also we are not able to get access to device and ACS login also not wor...
My server LAN is – 172.30.1.0/24 , and using BGP for primary and secondary Links on a single HUB Router,I need to Load share the secondary Link by specific ip address ,172.30.1.5 and 172.30.1.6 server traffic only via the Secondary Link using BGP on ...
"If however there is a L2 switch for example between you and the BGP peer device then you would need to track the next hop because if the BGP peer goes down your end of the link would still think it was up as it is connected to the switch. YES , the ...
In General , if u share the best routing filter to isolate ISP1 and ISP2 it will be helpfullbecause it needs multiple scenario where one link and multiple links at spoke side. The problem is ISP1 is in mesh topology , so when the ISP1 is down it is s...
