Hi everybody,I had configured fax-relay with t38 in my as5300. I owuld like to know if there is a better way to send fax over ip, as simple as fax-realy. If there is, where could I read about it. Regards,
Hi ,I am trying to set an AS5300 to authenticate users when they dial into it. I am using clid_authen as the applicatio voice. The script ask correclty to my RADIUS server the user an password (ani,dnis) but when it send the tone indicating to dial t...
Hi Everybody, I have been working with cisco for some time (2 yers) with VoIP. I think is the best platform ever. My previous experience with it was over E1 with MFC/R2 signaling. Now I am facing a new project where I need to incorporate SS7 signali...
HI, I have an ATA 186 registered to a GK. And I have an AS5300 registered to my GK too(without tech-prefix).What should I set in the GK to route a call from the ATA to the GW....I would be very gratefull If somebody could help me..Regards,
Hello, I have a Cisco AS5300 working as Gw and a Cisco 2600 working as GK. I did not configure my gateway to register with my GK but it register automatically . WHY????. How could configure my cisco so it does not register to my gk ....Regards,
I had done that...But when I dial the e164 number from other GW that is registered in my GK (in order to reach that GW) it fails the call. (it dont even appear in the sh ga call commands). CAn you tell me how to set the route in order to reach that G...
Thank you for your quick reply :)I've just talked with the one from the other country who gave us that FR configuration, and I asked him why were we using that configuration, if it was for the priorization for VoIP packets and rtp compression..he sa...
Hi..I have been working for some time with Clarent Gatekeeper and Cisco's ATA 186. They are working fine, but in some destinations we don't have ring back .(I cant help you with that because I am still with the problem).But with the audio problem yo...
I am using a AS5300, I dont really know if you could use the commands of my OS but in the AS5300 I use the ds0-group command, where I assign a pots dial-peer for origination and another pots for termination. for each pots I assign a group of timeslot...
The time from setup-time to connect-time is the no active call time (rings). From connect time to disconnect-time is the time of active call (when user talks). Verify that with a number where nobody answers and take the time of the rings and then wat...