Raul Ricano

After working with Cisco TAC the issue seemed to be caused by having an IP SLA that was routing icmp...

What was your resolution? I have the correct scripts, dialer and config, but still flaps on Cell 0 *...

Try changing your NAT at site A from (outside1,outside1) to (inside,outside1). Also can you post the...

Hi sorry for dropping off. Been traveling etc. So looking at the icmp traces you ran it fails at the...

That looks good. What version of ASA Code are you running? If you are running 8.3 and above you will...

At Site B it looks like its actually being Nat/PAT out to the internet and not exempt from NAT. Make...

I used iPerf for bandwidth testing through the VPN tunnels. Actually found out my application was us...

run: packet-tracer input inside icmp SourceIP 8 0 RemoteIP Post the results as well as your VPN conf...

You are correct that your command fixes that problem. However I have the same issue right now runnin...

Ended up resolving my issue by deleting the reporting DB and basically rebuilding it. Hope this help...

Importing SSL Certificate into IOS Router. (Marking for search ability) After much research and fail...

Hope you got your issue figured out. For me it was due to a config line forcing the old certificate....

Thank you for this article and easy to follow break down. I was able to troubleshoot an issue with a...

I am having this same issue. Did you ever get this figured out? Thanks,Raul

Did you ever get this figured out? I am actually looking to do the opposite going from an S170 to a ...