Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to pass Json variables using a POST through the body and can not seem to apply the format body fields in a way that UCCX editor will allow. In tests using Postman we were able to make the POST with the following string in the body as ra...
I had the same, or at least a very similar experience with our 8821's. The phones would get on the network and show as registered in CUCM, however when there was a call to or from the 8821 phone (running either firmware Active Load ID: sip8821.11-0-...
I had the same, or at least a very similar experience with our 8821's. The phones would get on the network and show as registered in CUCM, however when there was a call to or from the 8821 phone (running either firmware Active Load ID: sip8821.11-0-...
My Manager found this thread and it seems to work so far. https://community.cisco.com/t5/contact-center/uccx-rest-call-post-json-body/m-p/4308330 The last post in that thread is the one I followed. "{'serverName': 'myServer.domain.com'}""{'serverName...
Thank you for the reply I did have it formatted incorrectly. The following is what I should have posted... {"Context":"scheduling","UserID":"mruiz2","ContactType":"Incoming","CommunicationType":"Phone","PhoneNumber":"9876543210","PatientID":{"ID":""...
