Thank you. Yesterday I was able to manually extract the tar for 12.2(58)SE2. Still would like to resolve the issue with the flash memory. We use LMS to do code upgrades, and when LMS cannot find the desired flash, the job fails. For this switch it was looking for 64meg. I think this can be manually adjusted within LMS, but wonder where the memory went.
... View more
I have a few devices in LMS that are reporting several(close to 100) OutOfRange and OperationallyDown messages. The following are a couple of examples: Event_Description OutOfRange Component TEMP-172.16.1.1/3002 [Chassis 1 module 4 power-output-fail Sensor-Chassis 1 module 4 power-output-fail Sensor] ComponentClass TemperatureSensor ComponentEventCode 1079 Status OK entSensorValue 1 CurrentValue 1.0 DEGC RelativeTemperatureThreshold 20.0 % HighThreshold 0.8 DEGC Event_Description OperationallyDown Component CARD-172.16.1.1/3011 [Chassis 1 WS-F6700-DFC3C Distributed Forwarding Card 3 Rev. 1.0-Chassis 1 WS-F6700-DFC3C Distributed Forwarding Card 3 sub-module of 4] ComponentClass Card ComponentEventCode 1073 Status NOTPRESENT For the top example I have modified the RelativeTemperatureThreshold to 20% from 10%. Just not sure if that kind of action is recommended, as their are many devices in Switches nand Hubs that are affected. I know I can make certain groups for certain devices or that I could simply clear these kinds of notifications. But was wondering if there was another good way around these kinds of problems or notifications. I have checked the switches that I am being notfied on and see no issues. Any suggestions? Any DFM upgrade that I am not aware of? Thanks for any help or suggestions. Jason
... View more