I have downloaded the new firmware for the SG500. I see there are two files included in the download, a boot file (rfb) and regular firmware image (ros). I have looked and haven't seen anything about the rfb files. I know it is a boot file, but...
We are installing a Mitel VoIP system. The switch is in layer 3 mode. My data is currently on VLAN 1, untagged and PVID 1 (10.10.1.0/24). In preparation for the new VoIP, I setup a VLAN 30. It is VLAN 30, tagged (10.10.2.0/24). The ports are i...
Telling the phones to tag the traffic solved like 90% of my problems. Go on the config on the phones and verify that it is using your vlan 2. My setup was saying vlan none. If you need to change it on the phone, it is under the L2 settings. Also...
I finally got this fixed. I'm still not 100% sure why it didn't work before, but this was all for a Mitel VoIP system. The installer had not been setting the phones to use VLAN30. Once I changed that on each phone and made the ports trunks, vlan1...
The laptop is 192.168.2.254, 255.255.255.0, 192.168.2.1 for the gateway. The desktop is 192.168.1.200, 255.255.255.0, 192.168.1.1 for the gateway. Below is the running config. I am running v1.2.7.76.config-file-headerSG500v1.2.7.76 / R750_NIK_1_2_...
When I ping it, the first hop is from the VLAN1 interface, there is not a 2nd hop, but on line two, it says 10.10.1.1 reports: destination host unreachable.