Hi,With cost command ' ip ospf cost X ' on interface, it will affect all the network subnet's cost comming via that interface.So, is there any way that we can change the cost of selected network subnet in OSPF ?Pls ask is any more...
Hi,I have 7200 router.Can any one tell me that how can I check the ds3 link alarms on 7200 router.I have minimum access on router.Waiting for reply....
HiAccordign to my knowledge latency is 'the time measured from when packet enter into router to the time it out from router'. Is it right? I am confused so How to check or calculate it for leased lines like t1 and ds3.Thanks and RegardsKunal
I am with the similar query in my mind and ultimately reach to this discussion.But in CCIE R&S LAB, what should be the correct approach? Again is there ANY technical functionality difference between these two methods.
Hi Sandeep,YES it's achievable !!! I tried to match your scenarion as much as possible & tested it in GNS3. Hope it is as per your requirement.Attached only topology diagram for you reference. I can attached the entire configuration if you want, bu...
