About saifuddin.miyaji

saifuddin.miyaji · 01-04-2024

Hi,We have a cluster of Cisco Hyperflex systems and looking to replace two failed HDDs. These failed SAS drives are visible as "Blacklisted". Please advise if any special precaution is required while replacing these HDDs as I have seen some posts com...

saifuddin.miyaji · 01-14-2023

Hi, We are migrating to FPR 1010 from ASA 5500X series. Attached is the topology for the site to site VPN.The VPN tunnel established well and traffic is passing through.The challenge that we are facing is for the NAT on the the tunnel. We have very s...

saifuddin.miyaji · 01-11-2023

HiWe are trying to register a local gateway with Webex and not able to get through.- Webex hub has been configured as per the help.webex.com document. It generated the credentials like domain, registrar, username passwords, ect.- Credentials provided...

saifuddin.miyaji · 01-20-2022

CP8831 has been configured with CME 12.0. The phone registers well but does not show the option for ConfList. A template has been configured and applied on the pool. But this seems to have no affect on the phone while in conference (connected state)....

saifuddin.miyaji · 07-05-2021

Hi,We are trying to configure an authenticated SIP trunk towards the ITSP. The registration looks good. We are able to receive incoming calls but outbound calls are failing. Here is the relevant configuration:sip-uacredentials username 55507210 passw...

saifuddin.miyaji · 10-10-2023

The issue was these commands:voice class tenant 200 ... bind control source-interface g0/0/0 bind media source-interface g0/0/0It must be entered as :voice class tenant 200 ... bind control source-interface GigabitEthernet0/0/0 bind media sourc...

saifuddin.miyaji · 01-15-2023

Factory reset and reconfiguration has resolved the issue.

saifuddin.miyaji · 01-14-2023

Thank you for the suggestion. I have already gone through this document and configured accordingly.My problem is that there is an ugly looking IPV6 nat translation which is always hit first and so the manually created entries are not hit. This ipv6 n...

saifuddin.miyaji · 01-11-2023

Bingo!!!!Your hawk-eye caught it precisely. I cant think of it that a command has been accepted and yet not auto completed in configuration.Yes, we started the configuration with 16.9 IOS-XE and then upgraded to 17.X.X but neither of the IOS complain...

saifuddin.miyaji · 01-11-2023

We have tried several debugs including ccsip non-call but no relevant output received. Debug file attached.

Member Since	‎09-18-2008 10:06 AM
Date Last Visited	‎01-11-2024 02:53 PM
Posts	198
Total Helpful Votes Received	65

User Statistics

User Activity

Cisco Hyperflex HDD Failure

FPR 1010 NAT Issue

Webex Local Gateway Registration Issue

CP-8831 ConfList Missing

SIP Trunk Outbound Call Failure

Re: Webex Local Gateway Registration Issue

Re: FPR 1010 NAT Issue

Re: FPR 1010 NAT Issue

Re: Webex Local Gateway Registration Issue

Re: Webex Local Gateway Registration Issue