Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- :
- About michael o'nan
michael o'nan
Enthusiast
CCIE Collaboration Written (Lab scheduled 2/15)
CCNP (R/S, Voice)
CCNA (R/S, Voice, Security, Wireless)
CCDA
#CiscoChampion
Recent Badges
Stats
Member since
04-30-2012
320
Posts
116
Helpful
37
Solutions
Created by
michael o'nan
in IP Telephony and Phones
in IP Telephony and Phones
01-16-2015
08:43 AM
01-16-2015
08:43 AM
You could do POTS line direct to the telephone or you could buy a FXS card that way you can extension dial between the analog phone and the IP phones.
... View more
01-13-2015
07:12 AM
Variphy has a great CDR solution. There are others out there as well but that was my preferred vendor after looking at other solutions.
... View more
12-30-2014
08:26 AM
Sounds like you have a translation profile then. Will you post the config of your CME?
... View more
Created by
michael o'nan
in IP Telephony and Phones
in IP Telephony and Phones
12-30-2014
08:18 AM
12-30-2014
08:18 AM
Sounds like when it was setup the provider is asked how many digits you wanted to be presented with. Or they just strip to 4 digits by default unless asked for something different.
... View more
Created by
michael o'nan
in Other Collaboration Subjects
in Other Collaboration Subjects
12-29-2014
06:10 PM
12-29-2014
06:10 PM
For Advanced: http://www.cisco.com/web/partners/specializations/collab-arch.html For Express: http://www.cisco.com/web/partners/specializations/collab-arch-express.html Follow the links and look at the different roles and required tests. Once you have that completed you can fill out a form to submit to Cisco to be recognized partner with specialization.
... View more
12-29-2014
06:06 PM
try debug ccsip messages Depending on your translation pattern and where it is applied determines your digit manipulation from 10 digit DID to extension.
... View more
12-19-2014
10:32 AM
Not reset - reSEAT. Pull the card out of the slot and push it back in. If the problem still continues then you will need to set the diagnostic level to complete and reseat again. Could turn out to be a hardware issue on that card and you may need to open a TAC case. http://www.cisco.com/c/en/us/support/docs/switches/catalyst-6500-series-switches/41265-186-ErrormsgIOS-41265.html
... View more
Created by
michael o'nan
in IP Telephony and Phones
in IP Telephony and Phones
12-19-2014
10:29 AM
12-19-2014
10:29 AM
Have you pulled the logs yet? You should also have voice iec syslog enabled as well.
... View more
Created by
michael o'nan
in Wireless and Mobility
in Wireless and Mobility
12-19-2014
10:27 AM
12-19-2014
10:27 AM
I'm assuming the server is in a different subnet and is why you need helper address. On VLAN 10 you would set the helper address to be the IP address of the DHCP server.
... View more
Created by
michael o'nan
in Other Wireless - Mobility Subjects
in Other Wireless - Mobility Subjects
12-19-2014
10:25 AM
12-19-2014
10:25 AM
Would VLAN34 be the assigned management IP address on this controller?
... View more
12-19-2014
10:24 AM
To me it looks like the issue may be that your 300 switch is tagging 231 going upstream to the 3750. On the 3750 you should try to remove the native command and just leave it as an 802.1q trunk and prune all VLANs except 231.
... View more
Created by
michael o'nan
in Other Data Center Subjects
in Other Data Center Subjects
12-19-2014
10:19 AM
12-19-2014
10:19 AM
I don't have any problems with 3750X with DRAC or iLO cards. Maybe you should consider upgrading the IOS?
... View more
12-19-2014
09:57 AM
You might consider putting a lease timer on the DHCP pool. Since it seems 3 days is the magic number I would set for either 1 or 2 days. ip dhcp pool data lease 2 You can then monitor how many available addresses there are with show ip dhcp pool
... View more
01-16-2015
You could do POTS line direct to the telephone or you could buy a FXS
card that way you can extensio...
01-13-2015
Variphy has a great CDR solution. There are others out there as well but
that was my preferred vendo...
Created by
michael o'nan
in Unified Communications Infrastructure
01-05-2015
01-05-2015
What type of phone system are you running? Are they individual CMEs at
the remote site or are they a...
12-30-2014
Sounds like when it was setup the provider is asked how many digits you
wanted to be presented with....
12-29-2014
For
Advanced:http://www.cisco.com/web/partners/specializations/collab-arch.html
For
Express:http://w...
12-29-2014
try debug ccsip messagesDepending on your translation pattern and where
it is applied determines you...
12-19-2014
Not reset - reSEAT. Pull the card out of the slot and push it back in.
If the problem still continue...
12-19-2014
I'm assuming the server is in a different subnet and is why you need
helper address. On VLAN 10 you ...
Created by
michael o'nan
in Other Wireless - Mobility Subjects
12-19-2014
12-19-2014
Would VLAN34 be the assigned management IP address on this controller?
12-19-2014
To me it looks like the issue may be that your 300 switch is tagging 231
going upstream to the 3750....
Public Statistics
| Date Registered | 04-30-2012 12:59 PM |
| Date Last Visited | 03-24-2019 10:31 AM |
| Total Messages Posted | 320 |
| Total Helpful Votes Received | 116 |
.jpg "Hall of Fame Community Legend"){kind=icon}
.jpg "VIP Advisor"){kind=icon}
Helpful Votes From
