I have just started to look at hosted CML I can't find a way to connect my local Ansible to a CML lab Can anyone point me to a guide on how to connect via IP from my laptop to the CML routers. I can get the remote consoles working but now want to use...
I have setup a stack of 3 x Cisco Catalyst 9300's Switches are operational and fully manged via SSH I was going to look at the GUI so enabled ip http secure-server however when I connect to https://<switch ip>/webui it fails This Site cannot pro...
I am trying to make MACSec work between a pair of Nexus 7702's running 8.3.1 I have configured the macsec policy and key chainBut when I go to apply to the interface I get an error key chain K1 macseckey 01key-octet-string 7 075f701e1d5d4c53404a520d0...
I am deploying a pair of Nexus 7702 switches with Nexus 7700 F3-Series 48 Port 1/10GbE (SFP/SFP+) into 2 data centres, between the data centres there are 4 x 10G routed links
Is there an optimum port choice to maximise the bandwidth or will all po...
I have configured a VPC between a pair of Nexux 9Ks 93120TX Have enabled MST on both switches and now getting an inconsistency check error with global port type
Both switches are configured the same
spanning-tree port type edge bpduguard default
S...
Thanks for your reply. I can connect to the pre-built lab via ssh. what I want to do is build my own lab just not sure how to configure the "Bridge to Sandbox" connector?
I am also trying to do this but am missing something? CSR connected to external connector Gi4 picks up a DHCP address Enable username / ssh If I try to connect to this 192.168.255.x address it fails When I use the default lab all the connectivity g...
I am trying to do this also and using the Ansible Net_Put module It still uses SCP but I am hitting a command timeout also? This is the playbook section ## Copy software to target device- name: Copy Software Image to target devicenet_put:src: "~/n...
Thanks for this, however my situation is the switches are up and running and being managed by SSHIf I disable secure server I can manage via http for a bit
