Hello I would like to setup a new OSPF device on a vlan/subnet where 6 other NX-OSdevices are already operating, used as a transit segment: unfortunately all devicesrun MD5 authentication on their interfaces, and the secret is type 3 encrypted (Igues...
Helloafter upgrading a cluster of 5508s to 8.0MR3 from 7.6.130, 6 Flexconnect 1261 APsstarted looping, losing their registration after like 10 seconds and then powercycling themselves.In this WLC cluster i have lots of 1262 (dual band) working fine w...
Helloby means of 3750 or 2960-S stacks, it was impossibile to perform VSS dual active detctionusing ePAgP trough a MEC towards different members of a stack.Here the QA docs for 3850 state it is now supported:http://www.cisco.com/c/en/us/products/coll...
Hello Ric
here it is:
(Cisco Controller) >show ap join stats detailed 54:78:1a:a0:41:c0Sync phase statistics- Time at sync request received............................ Not applicable- Time at sync completed................................... Not ap...
Hi legacy data rates disabled ---> smaller cells Did you perform a survey after moving to 2602 APs? There's a chanceyou dont have enough signal or a good SNR for WiFi adapters not to tryroaming away from some cells. Check the result of TPC, what powe...
If you dont have subnets, you clearly dont have ip addresses:so why are you making references to layer 3? Furthermore, if you want to put different bridge groups (vlans)in communication beween themselves, why dont you just use only one? fp
