About lcuchisanmillan

lcuchisanmillan · 05-13-2013

Hello all,I have a question about ASAs in transparent mode with 9.1 software version.I have read that in the newer versions in transparent mode, you have to configure interfaces to belong to a bridge-group. Each bridge-group behaves independently fro...

lcuchisanmillan · 04-11-2011

Hello,We are making trials with all the load-balancing methods that GLBP and we are focusing when no load-balancing option is configured and as it says here it should work as HSRP:http://www.cisco.com/en/US/prod/collateral/iosswrel/ps6537/ps6554/ps66...

lcuchisanmillan · 10-15-2010

Hello all,We are having problems with ospf adjacency on a cisco 1900 router. The problem is the following:We have mora than 70 lines conected to a central router and only one is having adjancecy problems. At firts we thougth it was because of the mtu...

lcuchisanmillan · 09-17-2010

Hi all,We have a router with two interfaces connected to the sames ISPs router, running BGP in both interfaces: Serial0/0/0:0 10.11.8.106 YES NVRAM down down ATM0/1/0.1 ...

lcuchisanmillan · 07-06-2010

Hello all,We are having a cosmetic problem with a etherchannel connecting 2 Cisco 6500, via 2 gigabit interfaces in each side. The link is okay and is it working fine, is more a cosmetic problem. The devices are directly connected and when we do a "s...

lcuchisanmillan · 04-11-2011

Hi,It is router 2 (the one thta should be as standby) hat we reload or disconect, and when it goes up it becomes the active for 5-10 minutes,We have tested router 1 as 887 and router 2 as a 1921

lcuchisanmillan · 04-11-2011

Hi Reza,Thank for your response, what you are telling is what I thought I should work, but we have tested several times the following:Working normal, router 1 is active one.Reloading router 2, when it goes up Router 1 becomes standby and Router 2 is ...

lcuchisanmillan · 10-15-2010

Thank you, but the problem is resolved it was a line problem.But thank you all anyway!!

lcuchisanmillan · 10-15-2010

Hello M.I,Here you have the outputs you asked for:Remote: sh ip ospf int xx int xx is up, line protocol is up Internet Address IP, Area area_number Process ID id_number, Router ID IP, Network Type POINT_TO_POINT, Cost: 500 Topology-MTID Cost ...

lcuchisanmillan · 10-15-2010

Hi Mahesh,We are gpoing to try to do what you are saying.Tha ospf configuration is the following:sh run int tu1116Building configuration...Current configuration : 323 bytes!interface Xdescription Central Router 2Mbps(E)bandwidth 2000ip address IP wi...

Member Since	‎08-07-2006 10:55 PM
Date Last Visited	‎08-18-2017 04:00 AM
Posts	89
Total Helpful Votes Received	1

User Statistics

User Activity

ASA transparent mode bridge groups

GLBP working as HSRP

Problems with OSPF adjacency

Problems with BGP routes advertisement

Problems with etherchannels

Re: GLBP working as HSRP

Re: GLBP working as HSRP

Re: Problems with OSPF adjacency

Re: Problems with OSPF adjacency

Re: Problems with OSPF adjacency