Did you try it with adding "no switchport mode access" to the macros? ... View more

I finally got this working if anyone is interested. From my MacBook terminal I ran the following command:   curl -u admin1 -k -X DELETE https://<mntnode>/admin/API/mnt/Session/Delete/MACAddress/<macaddress>   It prompted me for the password of the user "admin1" and deleted the MAC.  You can also clear a specific session or delete all MAC addresses.  ... View more

Is it the same way to upgrade PI by using tftp? Thanks. ... View more

There's no guide that I know of just pay attention to the same basics as you would for an etherchannel to a 6500 for example with the addtion on the above spanning-tree command and be sure to use "mode on" for the port channel. HTH. Good luck! ... View more

hi i had that problem but it is solved now. before i used linux but it was not working with my ACS file than i used microsoft server 2012 guest operating system i was able to ping ACS ip with my laptop,but while in vmware i can not ping to laptop loopback ip address,but even i was able to see gui through web browser first check sh application status acs and you should wait for few minutes to get it initialize if it does not show anything than might be problem with that ACS file or you can uninstall that it and boot it again    ... View more

Hi Dennis, could you explain in a little bit more detail which timer you are talking about? We are getting a lot of these errors since we updated the WiSM/WCS from 5.2 to 6.0. ... View more

Thanks for the suggestion. In this case I have to do EAP and would like to know all of my options. I was able to get EAP-FAST to work using an external radius server but when using the local radius server on the ap I cannot get EAP-FAST to work. Ideas? ... View more

Is this patch going to be made publicly available for ACS 4.2 or do I still need to contact TAC? Also with ACS 5.1 the additional attributes shown in the above screen shot are still missing is there a patch available for ACS5.1 to get the additional attributes? TIA ... View more

I have seen similar cases where this can happen if the module is removed before "module clear-config" is set AFTER the module is already pulled from the chassis. Since you have already configured "module clear-config", can you put the original module back into the chassis, wait for it to come up completely, then remove it? This should do the trick. ... View more

We are currently testing the Cisco CB21ABG card with ADU 3.6, WPA+TKIP+CCKM as well as Intel 3945 WPA+TKIP+CCKM. Thus far testing is going well and we aren't experiencing the disconnects we were previously while roaming. We are extending the testing today to a nursing unit with 18 laptops to see if we still get good results. After speaking with Cisco the only supported configuration for fast secure roaming is the above config. They don't support WAP2+AES+CCKM. I will report back with results once I get them. On a side note we are still seeing the CB21ABG card doing a full reauthenticate against ACS every once in a while. CCKM is working correctly 90% of the time but still not 100%. This is another issue were still working with Cisco on. ... View more