Hi,After rebooting an ASA configured to redirect WCCP services 0 and 70 (HTTP and HTTPS) redirects to the Websense server have stopped. "I am here" and "I see you" packets perform correctly. The counters on the WCCP stats show that the redirects are ...
Hi,Does anyone know of a way of stopping EIGRP from converging back to a link if it is more preferable once it becomes available again?Scenario:Two sites, two links, 100Mb primary and 10Mb back up. EIGRP domain across the two sites, but the 10Mb is B...
Hi,I am experiencing an issue with Proxy ARP in my network, but only for one server.Our DG on our netowrk is an ASA 8.0(3) that has Proxy ARP enabled due to allocating a portion of the same internal range to remote hosts. I have one server on the net...
Hi Guys n Gals,I am having an issue with applying a route-map to an SVI to route certain traffic via a redundant link.The route-map is configured as follows,access-list 101 permit ip host 10.2.10.14 host 10.1.10.10 access-list 101 permit ip host 10.2...
Hi All,Is there a way of achieving the following.I have a site-to-site IPSEC VPN between two sites where the remote end accesses a URL connecting to a server at our end. This server is be re-allocated and we are wanting them to access a new one. With...
Hi,Flow control is a IEEE802.3x feature to allow a receiving deice to tell a sending device to pause transmition briefly to avoid congestion."Flowcontrol receive on" means that the switch requires the sending device to transmit flowcontrol "pause" fr...
Hi Tim,The scenario I briefly described would work. If you only have two switches in the recording domain that is.Switch A and Switch B are connected via an uplink trunking vlans. This is your data path.If you connected another link between these two...
Hi,You cannot have a local destination RSPAN port on a RSPAN source switch. So although your configuration is accepted, the only port the traffic from the switch B attached phone would be visible on is if the RSPAN destination port is on another devi...
Hi,K9 is the bit of that software string that is important for SSH. This means it is the crypto version and will have SSH feature availability.You can check the software advisor on the support page to be sure HTHWantser
All the documentation points to this conclusion.I do not have a device to confirm absolute though. But I cannot see Cisco changing this from one 2960 model to the next.HTHWantser
