Dear Community.I'm trying to track some static routes via the outside interface and do not want to install a backup route when the static route fails.If tracking failed can the static route be removed from ASA firewall all together, which is redistri...
Dear Experts,I'm trying to get the VFC up in B22-FEX blade in Dell whic is connecting to Nexus 5596UP.Could you take a look at this and help please.Attaching the config of 5596UPThe message I get is# sh int vfc1033vfc1033 is down (Error Disabled - VL...
Dear experts,I have the following errordisabled state on VFc as below.(Trying to get FCoE up and running for FC and automatically read WWN from Dell blades (M1000e) with two Nexus B22 FEX for Dell)The Eth interfaces are showiingN5KMR2E1-1(config-if)#...
Access-list ALL IP any anyAccess-list all ICMP any anyaccess-group ALL applied to all interfaces, in and outtraffic not passing throughfrom ASA ping external IPs work via some interfaces and not otherNeed your help to get the traffic through the ASA....
HiI've setup two 3750-x in stacked configuration.I'm unable to ping between a PC on 1/0/1 and another PC on 2/0/1 (in VLAN1). However I can ping 1/0/1 to gateway A1 and 2/0/1 to gateway A2.A1 and A2 will be made Active/Standby, once the inter stack s...
Further to above,Two ASA 5585-X in two different locations with inside and outside using 10G in Active/Standby. The inside switches also have 10G, so can pass traffic between firewalls.Thinking of putting statefull failover over a VLAN on the inside...
Both VFCs and FCOEs are up now.(There was an issu in binding to interfaces.)Still not reading the WWNs and MACs from B22/Qlogic/DellM1000eLACP is enabled.Vlan 1 is nativePlease let me know of any info on how to read WWN and MAC details.
Additional information below.When port-channel 3 is set to switchport mode fex-fabric the VFC changes to error disabled, but FcOE channels (1-15) changes to UPWhen port-channel 3 is set to switchport mode trunk, the VFC changes to UP, but FCoE chann...
Two config files and one diagram attached.We have two Cisco B22 fabric extenders in our M1000e chassis, and are single homed to the two Cisco Nexus 5596UP, with 2 links on each switch. We are unable to see the WWN’s of the servers in the blade chassi...
Hi Leo and others,Is the Nexus version i have is suitable for B22 FEX for Dell?Asking this because of the following web info: Support for DELL FEX Added support for the Cisco Nexus B22 DELL fabric extender. http://www.cisco.com/en/US/docs/switches/...
