I'm preparing for a code upgrade to nx-os 6.2. On one switch I got disconnected while running a "show install all impact".
The disconnect was a network problem, now that's fixed I try to run it again
show install all impact kickstart bootflash:m9500...
I'm curious as I've not used the bugsearch utility in some time. I was looking for issues in nx-os 6.2 for MDS 9000. I went for a status of Open and Support cases "has support case" left other filters blank. I found only 15 issues that to me were al...
I have Cisco MDS 9509 switches running nx-os 5.2(6a). I'm behind on the supported version. I need to get to at least 5.2(8f) as of today 2015/08/11. The latest GA is 6.2(13) . I'm thinking of some version of 6.2 as a target for the switches and DCN...
due to a migration I've been doing a lot of port debugging recently. Just curious it seems like something gets cleared when I do disable , enable from device manager that does not happen when I do a int, shut no shut - am I dreaming this?
Of course you can. Some like to put all the tape drives in one zone, or all the nodes of a cluster. I personally quit doing that years ago. I do all the zone building via scripts (can send an example if you like) which first minimizes mistakes and ...
I've refererences to TCAM usage , and I understand that "large zones" use more resources. The formula is n*(n-1) where n is the number of members. So how to I see and/or monitor TCAM usage?
Back Again, the more I read the worse it gets. BUT! I do now know that for Brocade NPV is Actually called Access Gateway (AG). So far this looks to me like I don't want to do this!
