I'm preparing for a code upgrade to nx-os 6.2. On one switch I got disconnected while running a "show install all impact".
The disconnect was a network problem, now that's fixed I try to run it again
show install all impact kickstart bootflash:m9500...
I'm curious as I've not used the bugsearch utility in some time. I was looking for issues in nx-os 6.2 for MDS 9000. I went for a status of Open and Support cases "has support case" left other filters blank. I found only 15 issues that to me were al...
I have Cisco MDS 9509 switches running nx-os 5.2(6a). I'm behind on the supported version. I need to get to at least 5.2(8f) as of today 2015/08/11. The latest GA is 6.2(13) . I'm thinking of some version of 6.2 as a target for the switches and DCN...
due to a migration I've been doing a lot of port debugging recently. Just curious it seems like something gets cleared when I do disable , enable from device manager that does not happen when I do a int, shut no shut - am I dreaming this?
Back Again, the more I read the worse it gets. BUT! I do now know that for Brocade NPV is Actually called Access Gateway (AG). So far this looks to me like I don't want to do this!
I cured the "no backup happened" by running a script (assuming your tftp is linux/unix) via crontab that checks for a file with the right name and >0 bytes (actually went to higher number after some use history)
finally found a document that stated destination-profile xml email-addr callhome@cisco.comthis worked just fine on one switch, so far the second has not worked
