About pgurumu77

pgurumu77 · 07-20-2005

Is there a way to create subinterface on PIX 515E 7.0 version single context edition.I didpixfirewall> conf tpixfirewall(config)> interface ether 0pixfirewall(config-if)> nameif outsidepixfirewall(config-if)> duplex fullpixfirewall(config-if)> speed ...

pgurumu77 · 05-14-2013

One way of solving it is my using policy routing, if my destination is 216, then next-hop is XO.

pgurumu77 · 01-31-2013

Make sure to configure A's subnets as interesting traffic on both B and C and have proper routing from C pointing to the B (VPN peer IP address) as the next-hop for A's subnets. Make sure to have A's subnets known on B and the VPN should work without...

pgurumu77 · 03-10-2012

What is the local-pref for 10.10.16.0 subnet on CE1 and CE2, I am guessing CE2 has higher local-pref than CE1 and CE1 will prefer the routes via iBGP from CE2, since your redistribute BGP into OSPF, OSPF routers are preferred. If you want to fix this...

pgurumu77 · 03-10-2012

I do not know how else you would like to acheive it apart from re-architecting the network in a better way, if all your internal routes are 10/8 (i.e. 10.0.0.0 255.0.0.0) then use that network instead of all your individual subnets. or use the entire...

pgurumu77 · 03-10-2012

That (Higher Admin Distance) means your IGP route is preferred, because EIGRP (90) or OSPF (110) or IS-IS(115) or RIP (120) or STATIC(default: 1) routes are always preferred than iBGP (200) routes, this is common, is there a redistribution going on?s...

Member Since	‎07-20-2005 09:56 AM
Date Last Visited	‎08-18-2017 04:00 AM
Posts	20

User Statistics

User Activity

Creating Sub Interfaces on PIX 515E 7.0 Version

BGP help required

site to site

eBGP routes and rib-failure

Re: Policy Based Routing on 6509

eBGP routes and rib-failure