Hi Team Could you please help me find a solution, unfortunately i couldn't find a similar use case on the internet. I am sure someone in this forum has done this and i would like to understand the configuration migration process.Here is the sce...
Hi Guys
I am dealing with a very strange issue and cant seem to get my head around. I have a customer, they use DMVPN for some of the sites. Its a standard DMVPN setup nothing complicated at all. During an audit they identified that encryption ...
Hi Guys I have a customer that is using Cisco presence version 9.1.1 and they also have MS Lync 2013. They servers resides in the same DC with no Firewall in between. They are looking to federate these two applications. Can anyone please tell me i...
Hi Guys My scenario is to have a Single Cisco CUBE registered with 3 different providers. The purpose of three registration is to make some cheap calls and toll bypass. I can register with all three service provider using three Credential comma...
Hi Guys I have never tested this scenario and unfortunately don't have right equipment in hand to test this.Has anyone tested this or know for sure.Can LDP neighbourship be formed over an Atom session ?I have router a and router b connect via an mpls...
Hi Fransesco
We have started using IKE v2 and the AES 256 encryption for the payload instead of 3DES.
Thats all we have changed. Absolutely nothing else.
Yes i can ping the SAP server with 1500 by MTU from the PC. However tunnel interf...
try this command on IOS..In IOS 15.X its a security feature to prevent fraud...voice service voip no ip address trusted authenticateor if u wanna keep router secured..then something like this ...depending on the IP used in your network..voice service...
Dear RobertYour reply confirms that my understanding was right. Thanks for your reply. My last question. Let's say I have two nexus 5596 switches. Sw1 and 2 And I have a stack of 3750 switches. Can 3750 stack connect to sw1 and sw2 and ether-chan...