I am having a difficult time setting up a proper multi-regional fabric. In a typical SDWAN Fabric, any service VPN prefixes get advertised to other edge routers running the same service VPN by default. But when the routers and an associated TLOC are ...
I am trying to upgrade an ISR 4331 running 17.3.4a to 17.9.4a. The device is in Controller-Managed mode. I have been unable to push the new software via vManage while getting a "boot partition cannot be found". It should also be noted that it appears...
So there is a ton of Ansible documented modules for ACI, IOX, XE, etc. I am having a tough time finding the Ansible Documentation for Cisco SD-WAN. Looking for the format similar to docs.ansible.com. Can anyone throw me a bone? Thanks,
When onboarding new edge routers, when is a device considered to be onboarded? Does a device need to be in vManage mode to be officially declared "onboarded"? The reason I ask is some documentation says that a device template is required for onboardi...
All, I was looking to find out if anyone knew how the ASA DCHP server works on an ASA firewall? How does it determine what IP addresses to hand out? I ran into a situation where it appeared as if the ASA was handing out IP addresses that were alread...
UPDATEWhat I am trying to accomplish here is the following:I have 2 border routers servicing the same access region. Both Border routers have the same service VPN created on them The border routers need to learn each others prefixesIt seems as if I a...
packages.conf file is not there. I am beginning to think I am going to have to convert back to autonomous mode to get it converted to install mode. Maybe I can copy the packages.conf file from another device?
I will give this a shot although the install command give the input below and nothing else really happens. I would expect the install command would create the package but I could be wrong. WR2#request platform software sdwan software install bootflas...
Do you know where I can find any documentation on how the ASA determines the IP address to hand out? I am trying to find the finer details in the ASA DHCP operation. Config guides do not tell me much. Thanks, Jason
