we have difficulties to run a vzen cluster and Zscaler support is not able to advise the setup on nexus 1000vThey just provide how to setup a standard vSwitch which is: The Promiscuous mode option must be enabled (i.e., set to Accept) on the vSphere ...

want to upgrade N5548UP from 5.2(1)N1(9) to 5.2(1)N1(9a) but the issu pre-check shows several port-channel interfaces, where servers are connected, as Non-Edge Ports although they are configured as "spanning-tree port type edge trunk"

Have a simple ACL: IPV4 ACL ERSPAN-FILTER        10 permit ip any 224.0.0.18/32 DS-J3-N5K-1(config)# monitor session 1 type erspan-sourceDS-J3-N5K-1(config-erspan-src)# filter access-group ?  WORD  Access control list nameDS-J3-N5K-1(config-erspan-s...

I'm running catalyst 4948 on version 15.0(2)SG10 where by default the management interface is running in the VRF "mgmtVrf". you can use this IF for e.g. tacacas and ntp if you make them aware of the VRF but NOT for syslog:DS-N8-C4948-2(config)#loggin...

we see increasing output drops on a veth interface on a nexus 1000v.DS-N1K-10# sh clockTue Apr 8 06:05:03 UTC 2014DS-N1K-10# sh int Veth19 | incl Drops    0 Input Packet Drops 415678974 Output Packet Drops...DS-N1K-10# sh clockTue Apr  8 06:06:07 UTC...