About n.indrajit

n.indrajit · 09-19-2010

Hi guys,I am facing problems to configure an ASR 1004 router, when I finish the basic configurations then I try to ping the router's interface (Interfaces are located in SPA module) itself but i couldn't; since the interface is up (Line and protoco...

n.indrajit · 09-22-2010

Hi Maria,We have consult with Cisco Engineers they have told our ASR is missing with a hw module "Embedded Services Processors (ESPs)" . Please check the followingThe Cisco ASR 1000 Series ESPs are responsible for the data-plane processing tasks, and...

n.indrajit · 09-21-2010

Maria,I have enabled the cdp on both devices but more than this i have checked the arp table from both side they are not learning other side mac address.ASR side interface i did "no negotiation auto" and manully configured duplex and speed but nothi...

n.indrajit · 09-20-2010

Hi Dimitri,Please check the following out putsASRGW#sho int GigabitEthernet1/0/0GigabitEthernet1/0/0 is up, line protocol is up Hardware is SPA-5X1GE-V2, address is 68ef.bdca.4e40 (bia 68ef.bdca.4e40) Internet address is 192.168.11.1/24 MTU 1500 ...

n.indrajit · 09-20-2010

Hi maria,Now i have removed vrf, please check the following out puts that u requestedASRGW#ping vrf Mgmt-intf 192.168.11.1Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 192.168.11.1, timeout is 2 seconds:.....Success rate is 0 percen...

n.indrajit · 09-20-2010

Hi Maria,Thank you for the reply.please check the following outputIn this setup ASR's interface GigabitEthernet1/0/0 and L3 Switch's interface GigabitEthernet0/27 both are directly connected and under same subnetASRGW#sho ip int brInterface ...

Member Since	‎09-19-2010 01:49 AM
Date Last Visited	‎08-18-2017 04:00 AM
Posts	8
Total Helpful Votes Received	5

User Statistics

User Activity

ASR 1004 configuration problem

Re: ASR 1004 configuration problem

Re: ASR 1004 configuration problem

Re: ASR 1004 configuration problem

Re: ASR 1004 configuration problem

Re: ASR 1004 configuration problem