About ciscouser50

ciscouser50 · 03-27-2016

Some time ago I created a LAG port on my SG3000-10 to connect it to a Dell VRTX switch module. I have just discovered that the LAG port is dropping packets. I never created an equivalent LAG port on the Dell VRTX switch. I have tried to create an equ...

ciscouser50 · 02-04-2015

Hi,I would really appreciate some help with an issue I have.I have a Cisco SG3000-10 in Layer 3 modeAn Asus wireless access pointA Dell switchThe AP and the dell switch are both plugged into the Cisco router. I am trying to get traffic to route from ...

ciscouser50 · 01-20-2013

Hi,I am looking for a router to route between VLANs on a Cisco Small Business 300 Series 10-port Gigabit Managed Switch.The router needs to support 802.1Q and also have Gigabit ports.I have been looking at the Cisco small business RV series of router...

ciscouser50 · 01-15-2013

I have bought a Cisco Small Business 300 Series 10-port Gigabit Managed Switch.I also have a Thompson ADSL router that connects my home network to the internet and acts as a wifi access pointI am wanting to create two VLANs on the switch one for mana...

ciscouser50 · 03-15-2015

Thank you all for your help.It was indeed the fact that the wireless router was not giving out the correct default gateway.Thanks again.

ciscouser50 · 01-22-2013

I think I am 99% there now.I upgraded the firmware on the router and changed it to Layer 3 mode.The issues is I still cannot ping between VLANs. Specifically via the trunk port.I read that routes are created automatically on the SG300 when a device i...

ciscouser50 · 01-21-2013

Apologies but I cannot get this to work.I have ADSL router connected to port 10.I have a server connected to port 1 which is Access, Untagged, VLAN 2If I set port 10 port to Trunk and tagged in VLANs 2, and 3 then I cannot access the server connected...

ciscouser50 · 01-21-2013

Thanks Karsten,So I should set the port that the ADSL router is connected to to Access?The issue I was having was I would set the port to Trunk but then when I would add it to the VLANs I would lose access to the switch via the ADSL router.

ciscouser50 · 01-21-2013

All, thanks for the help so far.Reza > Can I set the the port that my broadband router is plugged into to Trunk if the other end (my broadband router) does not support it.It is just a very basic ADSL router. I read that both ends of the cable need to...

Member Since	‎01-15-2013 01:26 AM
Date Last Visited	‎08-18-2017 04:00 AM
Posts	12

User Statistics

User Activity

LAG ports dropping packets

Routing issue

Which router to buy?

How should I achieve this?

Thank you all for your help

Which router to buy?

Re: Which router to buy?

Re: Which router to buy?

Re: Which router to buy?