we have both the 7960 and 7961 phones. They are all in the same CM groups/dial groups etc, but the 7961's will not dial out. The 7960 dials out just fine. Is there a new firmware version for the 7961 on CUCM 6.0, or where would I fine that?

we have both the 7960 and 7961 phones. They are all in the same CM groups/dial groups etc, but the 7961's will not dial out. The 7960 dials out just fine. Is there a new firmware version for the 7961 on CUCM 6.0, or where would I fine that?

I'm working on configuring SRST between CM 6.0 and 3845 router with CME on the router. I just came across the following restriction;The call-manager-fallback command, which is used to configure Cisco Unified SRST, cannot be used on a router that is c...

We have a 3845 ISR gateway (12.4T) and UCM 6.0. The gateway is registered via MGCP, but we cannot get the gateway "endpoint" to register. We have a VWIC T1 card, full T1 PRI, no question marks in "endpoint" configuration on UCM. I have followed the m...