Hi, I have an ASA with FirePower and also have 2 x FMC in a HA configuration (over a layer 3). My question is, how does the ASA FirePower senor know how to failover to the secondary FMC in the event the primary FMC dies? Since the initial configura...
Hi All, I am looking to implement IDFW on the network using Cisco ASA 55xx NG appliances. I understand the Context Directory Agent is not supported on ESXi 5.5 upwards and also potential support issues with Windows 2012 too. Looking at the download...
Hi,
I am in the process of evaluating FirePower on the ASA 5545-X. My Scenareio is as such;
I have Defence Centre VM installed.
2 x ASA 5545-X
1 x ASA FP configured on Primary ASA
FP module was running factory boot image of 'asasfr-5500x-boot-5.3...
Hi all,
I am looking for some guidance on the ASA1000v deployment in AWS cloud platform. I have tried following Cisco's instruction but am having issues. The image being used is of AMI from the market place. My environment is as follows;
1 VPC w...
Hi, I am in the process of setting up VPN for a client. Trying to understand why one would use RADIUS for VPN AAA rather than LDAP/AD?I am aware that most installs people prefer RADIUS over LDAP/AD, just trying to understand why as I know technicall...
Thank you for your reply. So to clarify;FMC's are in HA already.Once the ASA FirePower sensor is added with the primary FMC's IP, it should also receive config for the secondary FMC?If so, is there anyway to verify that from the console or is failing...
But the CDW is not maintained any longer and has not been for a good 3-4 years..Additionally, CDA is not supported on ESXi 5.0 and above and I believe there are support issues with Windows 2012/2016. I had raised a TAC case too and they have confirme...
But the CDW is not maintained any longer and has not been for a good 3-4 years..Additionally, CDA is not supported on ESXi 5.5 above and I believe there are support issues with Windows 2012/2016.I had raised a TAC case in too and they have confirmed ...
