Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
adibenedetto18
Level 1
Level 1
Member since ‎04-02-2007
‎09-20-2018
Recent Badges
Awards

User Statistics

  • 20 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
See all
10 Replies
5 Replies

User Activity

Interface VLAN inbound ACL?

09-06-2013
Hi, I maybe over thinking this but I have an ACL that is applied inbound on an interface vlan. I have a line to permit udp any any log which is temporary. I see hits but the source ip is off network to destination interface vlan ip address. I expect ...

ASA 5550 Flags E connection

05-03-2012
Hi, I have an issue were thousands of connections on the ASA are marked with flags E, below is a visual of the connection. Any ideas what could cause this marking? Also, I can't grasp what the meaing of an outside back connection (ie flags E). Thanks...

Default route redistributed

02-07-2012
Hi, I was wondering if there is a way to remove a redistributed default route from a branch router’s routing table automatically, when one router goes down. Example: R1 and R2 redistrubte a default route 0.0.0.0 to R3. If R1 goes down that default ro...

Cisco 7613 Input queue

12-05-2011
Hi, I was wondering what could be a cause for the input queue drops and flushes number to be the same. If you have any commands I can run to do some troubleshooting that would be great. ThanksFull-duplex, 1000Mb/s, media type is SX  input flow-contro...

Cisco ACE XML API

01-19-2011
Hi, I am trying to setup a simple html website to take a rserver in and out of service using the built in ACE module xml api. What would be the html code to post the xml command using a button? Currently I receive  <error err_num='103' err_str='XML_E...
View more
Community Statistics
Member Since ‎04-02-2007 06:10 AM
Date Last Visited ‎09-20-2018 10:55 AM
Posts 20