I have a request from management to configure our uc540 to allow users to break out of a hold queue. This means that that they could press a button and go an auto attendand for example. How would I best do this?
I am setting up inbound calling on my SIP trunk. I have run into a problem with inbound sip limitation with blast groups. If I have a certain number of users (more than 8), the initial blast group just rings and goes nowhere. I have confirmed this wi...
Hello. I have a UC 520 with fxo analog lines. Inbound calls never fail but every second outbound call on UC 520 fxo lines fails. It gives a fast busy signal. I tried lowering the call release timeout with no sucess. Any thoughts on this?
Similar yes, but not exactly. I have blast groups with 15-18 phones. Is your phone system working on a SIP trunk? Do you know of any hard limitations with blast groups on a SIP trunk? If so, can you find a way to work around it?