Hi Community,
I would like to use an ACL to limit the access to the HTTP(S) service of some C9300 switches using the "ip http access-class" command.
The goal is to allow many /19 subnets where only the 2nd octet differs with just a single entry in th...
Dear Cisco Community,
I am wondering why the Intelligent Packet Capture feature on DNA Center is not enabled by default on all managed WLAN APs that do support this feature.
Is it just because of the limited number of APs, that can be simultaneousl...
Dear Community, We experienced an unusual behavior of two Nexus 7000 switches within a vPC domain.According to the attached sketch, we have four N7Ks in two data centers - two Nexus 7Ks are in a vPC domain for each data center.Both data centers are c...
Hi, I just tested this in our lab environment (DNAC 2.2.3.3 and IOS-XE 17.3.4 on the Edge Nodes and IOS 15.2(7)E1a on the Extended Node).Actually, it is technically working fine with C9200 as well as C9200L acting as Edge Node and C3560CX acting as E...
Are there any plans to add Extended Node support for C9200 switches?I try to understand the reason, why this should not be supported on C9200 series switches.Is this a hardware or a software limitation? Best regards,Wilfried
Problem solved:During the reload of the Nexus 7K, the linecards were powerd off a short time earlier than the Mgmt-Interface. As a result of this behavior, the secondary Nexus 7K received at least one vPC-Peer-Keepalive Message while its peer-link wa...
