Hi There, I have recently done installation of Expressway E X8.5.3 with advanced option key activation.I do not see Dual network option in there under System Ethernet. Plus I do see an alarm that indicates something which I have no idea about.Here i...
Hi there,Are there any known issues on H323 ICT to SIP call flows?CUCM cluster A ( old version)-----H.323 ICT---------CUCM Cluster B ( new version)-------SIP trunk---Polycom bridgeRegards,Pankaj
Hi,Please refer to the call flow below PSTN--CUCM--TP--CISCO GW--T1---Avaya PBX TP* Translation pattern. Call comes in and hits a TP which further routes the call to a pattern pointing to Avaya PBX. Now, phones on Avaya PBX answers the call. Requirem...
Hi Everyone,Can we add PRI circuits on these WAN card's VWIC2-1MFT-G703 , VWIC3-1MFT-G703 ? Document says it supports unstructured/unchannelized E1 . Not sure if Voice is only supported via drop and insert config or timeslots can b...
Hi Everyone,I have a confusion about licensing on CUCM, I knew that there are DLU's , Node license and application license. But i am quite not sure what these licenses are used for ?CUCM-USR-LIC-ADD Top Level Sku For Adding User License LIC-CUCM-USR...
Yes, I was not able to see this option.Don't know how I noticed it only after I enabled my third NIC on EXpressway which I deleted earlier while experimenting, it sounds senseless to me though. I may have completely ignored this option while navigati...
Ok, duly accepted. But you know “customers”. They want things running even if this would never happen.So I wanted ideas, I know it’s a bit confusing and not so easy going requirement.
Here is the link which states that PRI group is supported on multiflex trunkshttp://www.cisco.com/en/US/docs/ios/12_2/12_2z/12_2zj/feature/guide/gthwecan.htmlSecond-Generation 1- and 2-Port T1/E1 Multiflex Trunk Voice/WAN Interface Cards Key Feature...
Thanks Paolo, i will definetly rate this but i am getting replies which are confusing me.Thanks Aman, yes the kind of config you are talking about is called drop and insert , where data is sent over certain allocated channels and voice over channels...
